Incorrect pitch after export | Forum di Polyphone

Claytonawilliams · 2024-09-13T15:22:00+00:00

Hey all! to start this off, i'm not too entirely sure wether this belongs in help or support & bug reports, but i figured it's probably not a bug since i'm very new to the software, but essentially, i'm working on some percussion instruments and i've done all the correct loop settings and set the scale tuning to zero for each instrument, however, after i get the soundfont into musescore, it seems to pitch it down and i just cannot figure out what i'm doing wrong, if anyone would be willing to help me, i'd be rather grateful i'll attach some screenshots below.

Accesso

Registrati

Questo forum permette a persone di tutto il mondo di comunicare, per questo i messaggi sono scritti in inglese.

2 0
Messaggio di Claytonawilliams il …

Hey all! to start this off, i'm not too entirely sure wether this belongs in help or support & bug reports, but i figured it's probably not a bug since i'm very new to the software, but essentially, i'm working on some percussion instruments and i've done all the correct loop settings and set the scale tuning to zero for each instrument, however, after i get the soundfont into musescore, it seems to pitch it down and i just cannot figure out what i'm doing wrong, if anyone would be willing to help me, i'd be rather grateful i'll attach some screenshots below.

2024-09-13 11-21-11.mkv
ZI 203 0
Messaggio di ziyametedemircan il … 1

The solution could be:
In the instrument section of Polyphone, set the root keys to be the same as the keys you assigned. This setting is important in non-pitched instruments. It ensures that the key you assigned produces the note in the original sample.

example:
Cabasa1: Key range 62 => Root key 62,
Cabasa2: Key range 64 => Root key 64, etc.
2 0
Messaggio di Claytonawilliams il …

HEYYYYYY! that was it! Thank you oh so much! I can finally progress!